Magic Loop 2.0 – Adapting Patterns, Purling, and More
Whee! Magic Loop is fun!
What's that you say? It's not perfect? You still get a little stuck sometimes?
Aha! Good! This is where we move from merely knowing a technique, to MASTERING it. It's in the little things! Here are a few tutorials to get things going smoothly.
Adapting any round pattern to Magic Loop
Many students ask me how to start using Magic Loop on patterns that don't specifically call for it. This is a good question, because hardly any patterns specifically call for Magic Loop.
Just like using a stand mixer is easier than mixing cookie dough with a spoon, but it's your choice which one you use, Magic Loop is just a technique - and a technique that most knitting designers don't expect you to know. They'll just tell you to mix the cookie dough with a spoon and be done with it.
When you see a pattern call for a set of DPNs or a certain length of circular needle, you'll know that the project is knitted in the round and that you can use your 47-inch needle and Magic Loop.
When the pattern says,"CO 40 sts and divide evenly on DPNs for working in the round," you just follow the technique we learned: CO 40 stitches onto your needle, slide them to the middle, divide the stitches in half, and proceed as in the pattern.
If your pattern calls for casting on an odd number of stitches, that's okay! Your needles will never know. Just divide the stitches as evenly as you can.
The only time that converting a pattern from DPNs to Magic Loop may present any kind of problem is when the designer instructs you to do things in relation to a certain needle.
This is common on small projects like socks and baby booties, e.g.,"K to end of 2nd needle, turn." In this case, you'll just have to look at how many stitches they told you to put on each needle in the first place (let's say it was 8), and do the math yourself: knit 16 and then turn.
I doubt you'll run into this problem very often, but if you do, you'll know what to do!
Pulling the first stitch too tight
This is the most common mistake among Magic Loop knitters who have switched from using DPNs. Knitters pull their first stitch tight in order to prevent a gap from appearing between the needles. Here's how to prevent a gap and also prevent your stitches from being too tight.
If you are having any difficulty getting your needle back into your stitches, you are probably pulling your first stitch too tight, trying to avoid ladders.
Starting the round with a purl stitch
A KnitFreedom member emailed me and asked,"What if I am starting the round with a purl stitch? I keep messing up!"
Does this sound familiar? If you knit American-style (with the yarn in your right hand), it is easy to get messed up.
The key is making sure the working yarn is underneath your right needle before you begin the stitch. Otherwise you will get an extra loop.
And there you have it! I'd love to hear your comments and especially gripes about Magic Loop.
- "Tinking" on Magic Loop - How to Undo Knitting in the Round
- How to Switch Needles on Magic Loop
- Key Cozy Pattern for Magic Loop
If you haven't already bought it, I highly recommend:
Complete Video Guide to Magic Loop
What did you think about this article on how to get even better at Magic Loop? Leave a comment below.
- Free Pattern: Basic Magic Loop Hat
- How To Bind Off On Magic Loop
- “Tinking” on Magic Loop – How to Undo Knitting in the Round
- Traveling Loop Method For Magic Loop
- Purling Tips: How To Purl On Magic Loop
- Getting Turned Around on Magic Loop
- Getting Turned Inside Out… In More Ways Than One
- The Best Circular Needles For Magic Loop
- How To Switch Needles on Magic Loop